Transmitting The Registered Dtmf Code; Setting Dtmf Autodialer Sending Speed - Yaesu FTM-3100R Advanced Manual

Advanced Operation

Transmitting the registered DTMF code

1. Press and hold in the [ MHz ( SETUP )] key for
one second to enter the Set mode.
2. Rotate the DIAL knob to select "DT AUTO
10".
3. Press the [ MHz ( SETUP )] key momentari-
ly, and then rotate the DIAL knob to select
"AUTO".
4. Press and hold in the [ MHz ( SETUP )] key for one second to save the new setting and
exit to normal operation.
Note: While the DTMF Autodialer is activat-
ed, the " " icon will appear on the
LCD.
5. In the Autodialer mode, which you just engaged, first press the PTT switch, then press
the microphone numeric key ( [ 0 ] through [ 9 ] ) corresponding to the DTMF memory
string you wish to send. Once the string begins, you may release the PTT switch, as
the transmitter will be held "on the air" until the DTMF string is completed.
To disable the Autodialer function mode, select "MANUAL" in step 3 above.

Setting DTMF Autodialer sending Speed

The speed at which the DTMF digits are sent can be changed.
1. Press and hold in the [ MHz ( SETUP )] key for
one second to enter the Set mode.
2. Rotate the DIAL knob to select "DT SPEED
13".
3. Press the [ MHz ( SETUP )] key momentarily,
and then rotate the DIAL knob to select the
desired speed ("50 MS": High speed or "100
MS": Low speed).
4. Press and hold in the [ MHz ( SETUP )] key for
one second to save the new setting and exit
to normal operation.
12
VOL
REV M H z
SQL
TXPO
D W
SETUP
VOL
REV M H z
SQL TXPO
D W
SETUP
FTM-3100R Advance Manual
DIAL
V / M
M W
DIAL
V / M
M W