Moving Memory Data To The Vfo; Memory Only Mode - Yaesu VX-3R Operating Manual

M M
EMORY
Data stored on memory channels can easily be moved to the VFO, if you like.
1. Select the memory channel containing the frequency data to be
moved to VFO.
2. Press and hold in the [ F/W ] key for one second, then press the
[ V/M ] key. The confirmation massage (V-WRT?
the display. Press the [ F/W ] key to cancel the Moving Memory
Data procedure, if desired.
3. Press the [ V/M ] key once more. The data will now have been
copied to the VFO, although the original memory contents will
remain intact on the previously stored channel.
If a Split Frequency Memory channel was transferred,
the Tx frequency will be ignored (you will be set up for Simplex operation on
the Receive frequency).
Once memory channel programming has been completed, you may place the radio in a
"Memory Only" mode, whereby VFO operation is impossible. This may be particularly
useful during public-service events, where a number of operators may be using the radio
for first time, and ultimate simplicity of channel selection is desired.
To place the radio into the Memory Only mode, turn the radio off. Now press and hold in
the [ V/M ] key while turning the radio on. To return to normal operation, repeat the above
power-on procedure.
50
ODE ( R
EGULAR
M M
OVING EMORY
M
EMORY
M C
EMORY HANNEL
D
ATA TO THE
V-WRT?) will appear on
V-WRT? V-WRT?
V-WRT?
O M
NLY ODE
VX-3R O
)
O
PERATION
VFO
M
PERATING ANUAL