Transmitting The Registered Dtmf Code; Setting Dtmf Autodialer Sending Speed - Yaesu FTM-7250DE Advance Manual

Advanced Operation

Transmitting the registered DTMF code

1. Press and hold the [ MHz ( SETUP )] key to enter the
Set mode.
2. Rotate the DIAL knob to select "DT AUTO 16".
3. Press the [ MHz ( SETUP )] key momentarily, and
then rotate the DIAL knob to select "AUTO".
4. Press and hold the [ MHz ( SETUP )] key to save the new setting and exit to normal op-
eration.
Note: While the DTMF Autodialer is activated, the
" " icon will appear on the LCD.
5. In the Autodialer mode, which you just engaged, first press the PTT switch, then press
the microphone numeric key ( [ 0 ] through [ 9 ] ) corresponding to the DTMF memory
string you wish to send. Once the string begins, you may release the PTT switch, as
the transmitter will be held "on the air" until the DTMF string is completed.
To disable the Autodialer function mode, select "MANUAL" in step 3 above.

Setting DTMF Autodialer sending Speed

The speed at which the DTMF digits are sent can be changed.
1. Press and hold the [ MHz ( SETUP )] key to enter the
Set mode.
2. Rotate the DIAL knob to select "DT SPEED 19".
3. Press the [ MHz ( SETUP )] key momentarily, and
then rotate the DIAL knob to select the desired
speed ("50 MS": High speed or "100 MS": Low
speed).
4. Press and hold the [ MHz ( SETUP )] key to save the
new setting and exit to normal operation.
15