Table of Contents
Advertisement
A
UTOMATIC
The VX-3R will automatically illuminate the LCD Lamp whenever the scanner stops on a
signal; this allows you to see the frequency of the incoming signal better at night. Note that
this will, of course, increase the battery consumption, so be sure to switch it off during the
day (the default condition for this feature is "ON
The procedure for disabling the Scan Lamp is:
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 74: SCN.LMP
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to set this Set Mode Item to "OFF
5. When you have made your selection, press the PTT switch to
save the setting and exit to normal operation.
The VX-3R will automatically "beep" when a band edge is encountered during scanning
(either in standard VFO scanning or during PMS operation). You may enable this feature
(band edge beeper) when the frequency reaches the band edge while selecting the VFO
frequency by the DIAL knob.
The procedure for enabling the Band-Edge Beeper is:
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 12: BP EDG
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to set this Set Mode Item to "ON
5. When you have made your selection, press the PTT switch to
save the setting and exit to normal operation.
VX-3R O
PERATING
L
I
AMP
LLUMINATION ON
B
E
AND
DGE
M
ANUAL
S
CAN
ON
ON").
ON
ON
SCN.LMP.
SCN.LMP
SCN.LMP
SCN.LMP
OFF
OFF
OFF
OFF."
B
EEPER
BP EDG
BP EDG.
BP EDG
BP EDG
ON
ON
ON
ON."
S
CANNING
S
TOP
65
- Quick Links:
- Reset Procedures
Hide quick links:
Advertisement
Table of Contents
