Selecting The Eai Mode And Its Transmit Time; Activating The Eai Feature - Yaesu VX-3R Operating Manual

E
MERGENCY
E
MERGENCY

Selecting the EAI mode and its Transmit Time

1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 31: EAI.TMR
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select the desired EAI mode (Interval
EAI "INT INT" or Continuous EAI "CON
INT INT
INT
40, and 50 minutes).
15 15, 20 15 15 15 20 20, 30 20 20 30 30 30, 40 30 40 40 40
5. Press the PTT switch to save the new setting and exit to normal operation.
A
CTIVATING THE
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 30: EAI
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select "ON
feature).
5. Press the PTT switch to save the new setting and exit to normal operation (with EAI
feature "ON").
When the EAI feature is activated, the "EAI
Number (or memory channel number) will appear alternately in the
Memory Channel Number Display Slot of the display.
To disable the EAI feature, just repeat above procedure, rotating the DIAL knob to select
"OFF OFF" in step "4" above.
OFF OFF
OFF
The VX-3R will ignore the EAI feature when the (1) the squelch is open, (2)
there is an incoming signal on the operating frequency, (3) the operating
frequency is the same as the frequency which is stored in the Memory Chan-
nel "EAI," or (4) a VHF frequency is stored in Memory Channel "EAI."
76
F
EATURE
A
UTOMATIC
CON") and transmit time (1 1 1 1 1 -10
CON CON
CON
EAI
FEATURE
ON" (thus activating the EAI
ON ON ON
ID ( EAI ) F
EAI.TMR EAI.TMR. EAI.TMR
EAI.TMR
EAI EAI
EAI. EAI
EAI" notation and the Band
EAI EAI EAI
VX-3R O
EATURE
10, 10 10
10
M
PERATING ANUAL