Programming A Member List - Yaesu VX-3R Operating Manual

(Requires all members set the same member list (includes own ID) into the same member
box in the same order.)
It is possible to register a maximum of 20 persons, in order to identify the sender. When
you receive a message transfer, you can know who sent the message by the ID in the
register. In addition, your ID can be sent to the members when you transmit any messages
to them.
If all the members share the register information (ID), the message sender ID will be shown
on the display when receiving the message.
Even if no IDs are registered, the message function can work. However, in this case, "MEM-
BER 1" though "MEMBER20 MEMBER20" will be displayed when receiving a message.
BER 1 BER 1 BER 1 BER 1 MEMBER20 MEMBER20 MEMBER20
We recommend that you use your call sign for the member list.
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 55: MSG.LST
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select the desired member box (01
20) into which you wish to store a member ID. The LCD will
20 20
20 20
display the previously stored personal ID.
5. Press the [ TXPO ] key momentarily to enable programming of
the personal ID.
6. Press the [ HM/RV ] key to clear the previously stored personal
ID, if desired.
7. Rotate the DIAL knob to select the first character of the personal
ID you wish to store, and then press the [ V/M ] key to save the
first character of the personal ID and move on to the next place.
8. Repeat previous step to complete the personal ID (up to 8 char-
acters). If you make a mistake, press the [ BAND ] key to move
back to the incorrect character, then re-enter the correct charac-
ter.
9. Press the [ HM/RV ] key to delete all data after the cursor that may have been previ-
ously stored erroneously.
10. When the personal ID entry is complete, press the [ TXPO ] key momentarily.
11. If you wish to store another personal ID, repeat steps 3 through 10 above.
12. Press the PTT switch to exit to normal operation.
VX-3R O
PERATING
P
ROGRAMMING A
M
ANUAL
M
ESSAGE
M L
EMBER IST
MSG.LST. MSG.LST MSG.LST
MSG.LST
01 ~
01 01
01
F
EATURE
MEM- MEM- MEM-
MEM-
71