Cloning - Yaesu VX-3R Operating Manual

C
LONING
The VX-3R includes a convenient "Clone" feature, which allows the memory and configu-
ration data from one transceiver to be transferred to another VX-3R. This can be particu-
larly useful when configuring a number of transceivers for a public service operation. Here
is the procedure for Cloning one radio's data to another:
1. Turn both radios off.
2. Connect the optional CT-27 Clone Cable between the MIC/SP jacks of the two ra-
dios.
3. Press and hold in the [ F/W ] key while turning the radios on. Do
this for both radios (the order of switch-on does not matter).
"CLONE CLONE" will appear on the displays of both radios when the
CLONE CLONE
CLONE
Clone mode is successfully activated in this step.
4. On the Destination radio, press the [ V/M ] key (" - - - - - WAIT
appear on the LCD).
5. Press the [ BAND ] key on the Source radio; " - - - - - - - - - - TX
pear on the Source radio, and the data from this radio will be
transferred to the other radio.
6. If there is a problem during the cloning process, "ERROR
be displayed. Check your cable connections and battery voltage,
and try again.
7. If the data transfer is successful, the Destination radio returns to normal operation and
"CLONE CLONE" will reappear on the Source radio.
CLONE CLONE CLONE
8. Turn both radios off and disconnect the cloning cable. You can then turn the radios
back on, and begin normal operation.
102
WAIT - - - - - " will
WAIT WAIT WAIT
TX - - - - - - - - - - " will ap-
TX TX
TX
ERROR" will
ERROR ERROR
ERROR
CT-27 Clone Cable
VX-3R O M
PERATING ANUAL