Yaesu VX-3R Operating Manual page 31

4. When you have made your selection of the CTCSS tone mode, press the PTT switch
to save the new setting.
5. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
6. Rotate the DIAL knob to select Set Mode Item 86: TN FRQ
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
7. Press the [ TXPO ] key momentarily to enable adjustment of the
CTCSS frequency.
8. Rotate the DIAL knob until the display indicates the Tone Fre-
quency you need to be using (ask the repeater owner/operator if
you don't know the tone frequency).
9. When you have made your selection, press the [ TXPO ] key momentarily, then press
the PTT switch, to save the new settings and exit to normal operation. This is different
from the usual method of restoring normal operation, and it applies only to the con-
figuration of the CTCSS/DCS frequencies.
1) Your repeater may or may not
re-transmit a CTCSS tone - some
systems just use CTCSS to control
access to the repeater, but does not pass it
along when transmitting. If the S-Meter de-
flects, but the VX-3R is not passing audio,
repeat steps "1" through "4" above, but ro-
tate the DIAL so that "TSQ" disappears - this
will allow you to hear all traffic on the chan-
nel being received.
2) During CTCSS operation, you may set up the VX-3R so a ringing "bell" sound alerts
you to an incoming call. See page 37 for details.
VX-3R O
PERATING
CTCSS/DCS/EPCS O
CTCSS O
M
ANUAL
PERATION
TN FRQ TN FRQ. TN FRQ
TN FRQ
CTCSS TONE FREQUENCY ( Hz )
67.0 69.3 71.9
82.5 85.4 88.5
100.0 103.5 107.2
123.0 127.3 131.8
151.4 156.7 159.8
171.3 173.8 177.3
189.9 192.8 196.6
210.7 218.1 225.7
250.3 254.1 –
PERATION
74.4 77.0 79.7
91.5 94.8 97.4
110.9 114.8 118.8
136.5 141.3 146.2
162.2 165.5 167.9
179.9 183.5 186.2
199.5 203.5 206.5
229.1 233.6 241.8
– – –
29