Using The Ftp Command From The Dos Prompt; Figure 189 Menu 24.5 Backup Configuration - ZyXEL Communications ZyAir G-2000 PlusV2 User Manual

Figure 189 Menu 24.5 Backup Configuration

Menu 24.5 – Backup Configuration
To transfer the configuration file to your workstation, follow the
procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current router configuration to your
workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in the menu to back up using TFTP), please see your router manual.

33.2.2 Using the FTP command from the DOS Prompt

1 Launch the FTP client on your computer.
2 Enter "open" and the IP address of your ZyXEL device.
3 Press [ENTER] when prompted for a username.
4 Enter "root" and your SMT password as requested. The default is 1234.
5 Enter "bin" to set transfer mode to binary.
6 Use "get" to transfer files from the ZyXEL device to the computer, for example, "get
rom-0 config.rom" transfers the configuration file on the ZyXEL device to your computer
and renames it "config.rom". See earlier in this chapter for more information on filename
conventions.
7 Enter "quit" to exit the FTP prompt.
Chapter 33 Firmware and Configuration File Maintenance
ZyXEL G-2000 Plus v2 User's Guide
Press ENTER to Exit:
337