Example: Tftp Command - ZyXEL Communications ZyAir G-2000 PlusV2 User Manual

5 Use the TFTP client (see the example below) to transfer files between the ZyXEL device
and the computer. The file name for the firmware is "ras" and the configuration file is
"rom-0" (rom-zero, not capital o).
Note that the telnet connection must be active and the SMT in CI mode before and during the
TFTP transfer. For details on TFTP commands (see following example), please consult the
documentation of your TFTP client program. For UNIX, use "get" to transfer from the ZyXEL
device to the computer, "put" the other way around, and "binary" to set binary transfer mode.

33.4.5 Example: TFTP Command

The following is an example TFTP command:
TFTP [-i] host put firmware.bin ras
where "i" specifies binary image transfer mode (use this mode when transferring binary files),
"host" is the ZyXEL device's IP address, "put" transfers the file source on the computer
(firmware.bin – name of the firmware on the computer) to the file destination on the remote
host (ras - name of the firmware on the ZyXEL device).
Commands that you may see in third party TFTP clients are listed earlier in this chapter.
Chapter 33 Firmware and Configuration File Maintenance
ZyXEL G-2000 Plus v2 User's Guide
345