Configuring Route Entry; Figure 49 Static Route: Edit; Table 45 Static Route - ZyXEL Communications ZyAir G-2000 PlusV2 User Manual

Table 45 Static Route

LABEL
#
Name
Active
Destination
Gateway
Edit
Delete

9.2.1 Configuring Route Entry

Select a static route index number and click Edit. The screen shown next appears. Fill in the
required information for each static route.

Figure 49 Static Route: Edit

The following table describes the labels in this screen.
Chapter 9 Static Route Screens
DESCRIPTION
Number of an individual static route.
Name that describes or identifies this route.
This field shows whether this static route is active (Yes) or not (No).
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is an immediate neighbor of
your ZyXEL device that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your ZyXEL device; over the
WAN, the gateway must be the IP address of one of the remote nodes.
Select a static route index number and then click Edit to set up a static route on the
ZyXEL device.
To remove a static route on the ZyXEL device, click the radio button next to the
static route index number you want to remove, then click Delete.
ZyXEL G-2000 Plus v2 User's Guide
131