Updating Firmware; Using A Firmware Upgrade Tape - Freecom VALUELOADER LTO User Manual

ValueLoader Administration

Updating Firmware

Updating Firmware

Using a Firmware
3
Upgrade Tape
40
Press the or
3 [+] [-]
the LCD screen. The second line displays the current status of
this mode.
Press the
4 [Enter]
are about to turn Autoload Mode on or off.
Press the
5 [Enter]
or press
[Cancel]
This section explains how to update firmware using either a
firmware upgrade tape or SCSI commands.
Regardless of the firmware update technique, DO
Caution:
NOT POWER CYCLE OR RESET THE
VALUELOADER DURING THE UPGRADE
PROCESS. Doing so could cause the ValueLoader to
become inoperable.
This option performs a firmware update for the ValueLoader and/
or the HP LTO drive using firmware upgrade cartridge.
This code update operation assumes that a slot is
Note:
available in the carousel for the upgrade cartridge, and
the upgrade cartridge is imported as part of this
procedure.
If the carousel is full, export a cartridge to make room for
the firmware upgrade cartridge. (See
Cartridges
the firmware upgrade cartridge before starting this
procedure.
ValueLoader LTO Tape Autoloader User Manual
button until "Autoload Mode" appears on
button. The LCD screen indicates whether you
button to accept the change to Autoload Mode
to exit and not save the changes.
on page 29 for instructions.) Do not import
Exporting
3