Terminator Board - Compaq 1600R - ProLiant - 128 MB RAM Maintenance And Service Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
2-24 Removal and Replacement Procedures

Terminator Board

IMPORTANT: If a single processor is installed, a terminator board
must be installed (Compaq ProLiant 1600 only).
To remove the terminator board from the Compaq ProLiant 1600:
1. Perform the preparation procedures. See page 2-2.
2. Remove the processor cage (see page 2-21) and open the cage door.
3. Lift up two levers on each end of the terminator board .
4. Lift the terminator board from the processor cage .
Figure 2-21. Removing the Terminator Board
Reverse steps 1 through 4 to replace the terminator board.
1
1
2