Compaq 1600R - ProLiant - 128 MB RAM Maintenance And Service Manual page 107

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
Starting DAAD
To start DAAD:
1. Insert the DAAD diskette into drive A.
2. Reboot the system - OR - if you are at the DOS prompt, enter the following:
NOTE: To generate a DAAD report without starting the interactive
portion of the utility, enter the following at the DOS prompt:
DAAD filename
where filename is the name of the file or report.
3. A dialog box is displayed, indicating the version of DAAD installed. Press the Enter
4. If you continue, a Please Wait panel is displayed, indicating that DAAD is
When the information gathering process is complete, the main DAAD screen is displayed.
NOTE: To generate a DAAD report without starting the interactive
portion of the utility, enter the following at the DOS prompt:
DAAD filename
where filename is the name of the file or report.
Table 3-20 lists DAAD diagnostic messages in alphabetical order.
A:DAAD
(or 'C') key to continue, or press the Esc (or 'E') key to exit without continuing.
identifying the system parameters.
DAAD gathers all the information it can from all of the array controllers in the
system. The time it takes to gather this information depends on the size of your
system.
A second Please Wait panel may be displayed to indicate that the utility is identifying
the ROM version of an array controller in the system.
CAUTION: Do not cycle the power; the utility must perform
low-level operations that, if interrupted, could cause the
controller to revert to a previous level of firmware if the
firmware was soft-upgraded.
Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide
3-53