Compaq 1600R - ProLiant - 128 MB RAM Maintenance And Service Manual page 138

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
3-84 Diagnostic Tools
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Dial-out
string
Network
status
Network
protocol
Network
controller
Network
host
name
Network
card slot
Network
frame
type
Network
IP address
Pager Setting
Data
555-1234
Enabled
Compaq
CPQHOU
Slot #
ETHERNET
_I I
Continued
Enter the dial string followed by the remote computer's
telephone number.
To allow network access to Compaq Utilities, set
Network Status to Enabled and make sure the Reset
Boot option is set to Boot Compaq Utilities.
To use IPX network access, set Network Protocol to IPX.
When the system restarts to the Compaq Utilities
because of an ASR reset, it loads IPX network support.
This enables remote access via NVT.
To use IP network access, set Network protocol to IP.
Also make sure to set Network IP address, Network IP net
mask, and Network IP router address. When the system
restarts to the Compaq Utilities because of an ASR reset,
it loads IP network support. This enables remote access
via Telnet.
NOTE: The Network Status must be set to Enabled for
network access.
For all Compaq Standard Network Controllers.
Enter the network name of the server. Use underscores
instead of spaces within the name, for example,
Compaq_Server. If you are using IPX network access to
the Compaq Utilities, this server name is used to
advertise NVT host services. This server name displays in
the Compaq Insight Manager server list when it
determines it can communicate via NVT. Set this name
to be the same as the server name you assign when the
host OS is running.
Select the slot number of the network interface card
you wish to use for network access to Compaq Utilities.
Select the frame type for your network. Selections
include both Ethernet and Token Ring topologies.
Enter the IP address for this server in standard dot
notation.
NOTE: This is not used if you select Custom for Network
controller. You must enter your IP address in the NET.
CFG file that you load into the system partition.
Description