Figure 3-9. Removing and Replacing a Redundant Power Supply
1
power supply
3
cable retention bracket
Installing a Redundant Power Supply
1 Verify that both power supplies are the same type and have the same
maximum output power.
NOTE:
supply label.
2 Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-9.
NOTE:
procedure, relatch it. For information about the cable management arm, see
the system's rack documentation.
3 Connect the power cable to the power supply and plug the cable into a
power outlet.
CAUTION:
When connecting the power cable, secure the cable with the
Velcro strap.
The maximum output power (shown in watts) is listed on the power
If you unlatched the cable management arm in step of the previous
1
2
locking tab
Installing System Components
2
3
93