Dell PowerEdge R410 Hardware Owner's Manual page 111

Dell server hardware owner's manual
Hide thumbs Also See for PowerEdge R410:
Table of Contents

Advertisement

6 Close the system. See "Closing the System" on page 83.
7 Reconnect the system and peripherals to their power sources, and turn
them on.
Removing an iDRAC6 Enterprise Card
WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 If present, disconnect the Ethernet cable from the iDRAC6 enterprise card
connector on the system back panel. See Figure 1-4.
3 Open the system. See "Opening the System" on page 82.
4 Remove the system board shroud. See "Removing the System Board
Shroud" on page 105.
5 Remove the VFlash media card (if installed) from the iDRAC6 enterprise
card. See "Integrated Dell Remote Access Controller 6 (iDRAC6) Express
Card (Optional)" on page 107.
6 Remove the iDRAC6 Enterprise card:
Pull back slightly on the two tabs at the front edge of the card and
a
gently lift the front edge of the card off of the retention standoffs.
As the card releases from the standoffs, the connector under the card
disengages from the system board connector.
Slide the card away from the back of the system until the RJ-45
b
connector is clear of the back panel, then lift the card out of the
system.
7 Replace the plastic filler plug over the port at the system back panel.
See "Back-Panel Features and Indicators" on page 17 for the port location.
8 Replace the system board shroud. See "Installing the System Board
Shroud" on page 106.
9 Close the system. See "Closing the System" on page 83.
10 Reconnect the system and peripherals to their power sources, and turn
them on.
Only trained service technicians are authorized to remove the system
Installing System Components
111

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

External oemr r410

Table of Contents