Dell PowerEdge R410 Hardware Owner's Manual page 133

3 Open the system. See "Opening the System" on page 82.
4 Disconnect the control panel cable at back of the control panel board.
• For LED control panel see Figure 3-25.
• For LCD control panel see Figure 3-26.
CAUTION:
Do not pull on the cable to unseat the connector. Doing so can damage
the cable.
Press the metal tabs on the ends of the cable connector.
a
Gently work the connector out of the socket.
b
5 For LCD control panel, disconnect the display module cable from the
control panel board. See Figure 3-26.
6 Remove the two screws that secure the control panel board to the system
chassis and remove the board.
This completes the removal for LED control panel.
7 Remove the display module:
Using a knife or a small flat-blade screwdriver, insert the blade beneath
a
the front panel of the display and slide the blade across the bottom to
lift the panel outward. See Figure 3-26.
Bend the panel upward to allow access to the mounting screws.
b
Remove the two screws that secure the display module to the system
c
chassis.
Remove the display module from the chassis cutout.
d
Installing System Components
133