Dell PowerEdge R410 Hardware Owner's Manual page 89

Dell server hardware owner's manual
Hide thumbs Also See for PowerEdge R410:
Table of Contents

Advertisement

Removing a Cabled Hard Drive
WARNING:
cover and access any components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Open the system. See "Opening the System" on page 82.
3 Disconnect the data/power cable from the hard drive in the drive bay.
4 Lift the tab with blue dot on the hard-drive bracket and slide the drive out
of the bay. See Figure 3-7.
Figure 3-7. Removing and Installing a Cabled Hard Drive
1
1
hard drive
3
tab
NOTE:
If you are not replacing the hard drive, remove the drive from the drive
bracket (see Figure 3-8) and insert the empty bracket back into the drive bay.
5 Replace the system cover. See "Closing the System" on page 83.
Only trained service technicians are authorized to remove the system
2
2
power/data cable
4
drive bracket
Installing System Components
3
4
89

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

External oemr r410

Table of Contents