Vflash Media (Optional); Cooling Fans - Dell PowerEdge R410 Hardware Owner's Manual

VFlash Media (Optional)

The VFlash media card is a Secure Digital (SD) card that plugs into the
optional iDRAC6 Enterprise card at the back corner of the system.
Installing a VFlash Media Card
1 Locate the VFlash media slot at the back corner of the system.
2 With the label side facing up, insert the contact-pin end of the SD card
into the card slot on the module.
NOTE:
3 Press inward on the card to lock it into the slot.
Removing a VFlash Media Card
To remove the VFlash media, push inward on the card to release it, and pull
the card from the card slot.

Cooling Fans

Your system contains four dual-motor fans and provides cooling for the
processor and memory modules and two dual-motor fans for the redundant
power supplies.
NOTE:
Hot-swap removal or installation of the fans is not supported.
NOTE:
In the event of a problem with a particular fan, the fan number is referenced
by the system's management software, allowing you to easily identify and replace
the proper fan by noting the fan numbers on the fan assembly.
Removing a Cooling Fan
WARNING:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
WARNING:
has been powered down. Allow time for the fan to stop spinning before removing it
from the system.
WARNING:
NOTE:
The procedure for removing each individual fan module is the same.
112
Installing System Components
The slot is keyed to ensure correct insertion of the card.
Only trained service technicians are authorized to remove the system
The cooling fan can continue to spin for some time after the system
Do not attempt to operate the system without the cooling fan.