Exit Menu; Maintenance Menu; Exit Menu Options - NEC POWERMATE 8100 Series Service And Reference Manual

Menu Item
Hard Drive
Removable Devices

Exit Menu

Selecting the Exit menu displays the exit options listed in the following table.
Menu Item
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults

Maintenance Menu

The Maintenance menu only appears when the system board has been jumpered
for Configure mode. (See Section 4, "System Board" for system board jumper
settings.) When the system is restarted in Configure mode, the Setup utility
launches automatically and comes up in the Maintenance menu. (The Main,
Advanced, Power Management, Security, Boot, and Exit menus are also
available.)
The Maintenance menu provides access to the options listed in the table on the
following page.
Starting the system in Configure mode resets BIOS settings
to their factory defaults. Before jumpering for Configure
mode, write down any customized BIOS settings. When the
system is started in Normal mode, press
BIOS Setup utility. Re-customize the BIOS settings.
Boot Menu Options
Settings and Descriptions
IDE drives. IDE drives are identified by auto-typing. Select an
IDE device from the option list with the up or down arrow, then
press the plus or minus key to change the device boot order.
Bootable ISA Cards. Select an ISA card from the option list
with the up or down arrow, then press the plus or minus key to
change the card's boot order.
Removable devices are identified by auto-typing. The first
device in the list is the bootable device.
Select a device from the option list with the up or down arrow,
then press the plus or minus key to change the device boot
selection.

Exit Menu Options

Settings and Description
Saves the setting just made and exits BIOS.
Discards the changes just made and reverts back to the
settings existing before starting the BIOS session.
Reverts to the factory-shipped settings.
! CAUTION
to bring up the
F2
System Configuration 2-23