Remote Node Network Layer Options; Figure 28-3 Menu 11.3 Remote Node Network Layer Options; Table 28-2 Menu 11.3 Remote Node Network Layer Options - ZyXEL Communications PRESTIGE 652H User Manual

Prestige 652 Series User's Guide

28.3 Remote Node Network Layer Options

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
IP Options:
IP Address Assignment= Dynamic
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Metric= 2
Private= No
RIP Direction= None
Multicast= None
IP Policies= 3,4,5,6
Press ENTER to Confirm or ESC to Cancel:

Figure 28-3 Menu 11.3 Remote Node Network Layer Options

The next table explains fields in Menu 11.3

Table 28-2 Menu 11.3 Remote Node Network Layer Options

FIELD
IP Address Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote
Assignment node is using a dynamically assigned IP address or Static if it is using a
static (fixed) IP address. You will only be able to configure this in the ISP
node (also the one you configure in menu 4),all other nodes are set to
Static.
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet Type the subnet mask assigned to the remote node.
Mask
28-6
Menu 11.3 - Remote Node Network Layer Options
Address Mapping Set= 2
Version= RIP-1
Bridge Options:
Ethernet Addr Timeout (min)= N/A
Remote Node Network Layer Options.
–
DESCRIPTION EXAMPLE
Dynamic
Remote Node Configuration