Figure 37-16 Menu 24.7.1 As Seen Using The Console Port; Figure 37-17 Example Xmodem Upload - ZyXEL Communications PRESTIGE 652H User Manual

Prestige 652 Series User's Guide
37.4.8 Uploading Firmware File Via Console Port
Step 1.
Select 1 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.1
– System Maintenance – Upload System Firmware, then follow the instructions as shown in
the following screen.
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
4. After successful firmware upload, enter "atgo" to restart the
Warning: Proceeding with the upload will erase the current system
firmware.

Figure 37-16 Menu 24.7.1 as seen using the Console Port

Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.
37.4.9 Example Xmodem Firmware Upload Using HyperTerminal
Click Transfer, then Send File to display the following screen.
After the configuration upload process has completed, restart the Prestige by entering "atgo".
37-14
Menu 24.7.1 - System Maintenance - Upload System Firmware
Xmodem upload on your terminal.
Prestige.
Do You Wish To Proceed:(Y/N)

Figure 37-17 Example Xmodem Upload

Type the firmware file's location, or
click Browse to look for it.
Choose the Xmodem protocol.
Then click Send.
Firmware and Configuration File Maintenance