No Security - ZyXEL Communications P-660HN User Manual

Chapter 7 Wireless LAN
Table 28 Network > Wireless LAN > AP
LABEL
802.11 Mode
Common Setup
Network Name
(SSID)
Hide SSID
Security Mode
MAC Filter
Edit
Apply
Cancel
Advanced
Setup

7.2.1 No Security

In the Network > Wireless LAN > AP screen, select No Security from the Security Mode
list to allow wireless devices to communicate with the ZyXEL Device without any data
encryption or authentication.
108
DESCRIPTION
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to
associate with the ZyXEL Device.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the ZyXEL Device.
Select 802.11n Only to allow only IEEE 802.11n compliant WLAN devices to
associate with the ZyXEL Device.
Select 802.11g/n mixed to allow either IEEE 802.11g or IEEE 802.11n compliant
WLAN devices to associate with the ZyXEL Device. The transmission rate of your
ZyXEL Device might be reduced.
Select 802.11b/g mixed to allow either IEEE 802.11b or IEEE 802.11g compliant
WLAN devices to associate with the ZyXEL Device. The transmission rate of your
ZyXEL Device might be reduced.
Select 802.11b/g/n mixed to allow IEEE 802.11b, IEEE 802.11g or IEEE802.11n
compliant WLAN devices to associate with the ZyXEL Device. The transmission rate
of your ZyXEL Device might be reduced.
The SSID (Service Set IDentity) identifies the service set with which a wireless device
is associated. Wireless devices associating to the access point (AP) must have the
same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for
the wireless LAN.
Note: If you are configuring the ZyXEL Device from a computer
connected to the wireless LAN and you change the ZyXEL
Device's SSID or WEP settings, you will lose your wireless
connection when you press Apply to confirm. You must then
change the wireless settings of your computer to match the
ZyXEL Device's new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
See the following sections for more details about this field.
This shows whether the wireless devices with the MAC addresses listed are allowed
or denied to access the ZyXEL Device using this SSID.
Click this to go to the MAC Filter screen to configure MAC filter settings.
Click this to save your changes.
Click this to restore your previously saved settings.
Click this to display the Wireless Advanced Setup screen and edit more details of
your WLAN setup.
P-660HN-Fx User's Guide