Table 105 Access Control Logs; Table 106 Tcp Reset Logs - ZyXEL Communications P-660HN User Manual

Table 105 Access Control Logs

LOG MESSAGE
Firewall default policy: [ TCP |
UDP | IGMP | ESP | GRE | OSPF ]
<Packet Direction>
Firewall rule [NOT] match:[ TCP
| UDP | IGMP | ESP | GRE | OSPF
] <Packet Direction>, <rule:%d>
Triangle route packet forwarded:
[ TCP | UDP | IGMP | ESP | GRE |
OSPF ]
Packet without a NAT table entry
blocked: [ TCP | UDP | IGMP |
ESP | GRE | OSPF ]
Router sent blocked web site
message: TCP

Table 106 TCP Reset Logs

LOG MESSAGE
Under SYN flood attack,
sent TCP RST
Exceed TCP MAX
incomplete, sent TCP RST
Peer TCP state out of
order, sent TCP RST
Firewall session time
out, sent TCP RST
Exceed MAX incomplete,
sent TCP RST
Access block, sent TCP
RST
P-660HN-Fx User's Guide
DESCRIPTION
Attempted TCP/UDP/IGMP/ESP/GRE/OSPF access
matched the default policy and was blocked or forwarded
according to the default policy's setting.
Attempted TCP/UDP/IGMP/ESP/GRE/OSPF access
matched (or did not match) a configured firewall rule
(denoted by its number) and was blocked or forwarded
according to the rule.
The firewall allowed a triangle route session to pass
through.
The router blocked a packet that didn't have a
corresponding NAT table entry.
The router sent a message to notify a user that the router
blocked access to a web site that the user requested.
DESCRIPTION
The router sent a TCP reset packet when a host was under a SYN
flood attack (the TCP incomplete count is per destination host.)
The router sent a TCP reset packet when the number of TCP
incomplete connections exceeded the user configured threshold.
(the TCP incomplete count is per destination host.) Note: Refer to
TCP Maximum Incomplete in the Firewall Attack Alerts screen.
The router sent a TCP reset packet when a TCP connection state
was out of order.Note: The firewall refers to RFC793 Figure 6 to
check the TCP state.
The router sent a TCP reset packet when a dynamic firewall
session timed out.Default timeout values:ICMP idle timeout (s):
60UDP idle timeout (s): 60TCP connection (three way
handshaking) timeout (s): 30TCP FIN-wait timeout (s): 60TCP idle
(established) timeout (s): 3600
The router sent a TCP reset packet when the number of
incomplete connections (TCP and UDP) exceeded the user-
configured threshold. (Incomplete count is for all TCP and UDP
connections through the firewall.)Note: When the number of
incomplete connections (TCP + UDP) > "Maximum Incomplete
High", the router sends TCP RST packets for TCP connections
and destroys TOS (firewall dynamic sessions) until incomplete
connections < "Maximum Incomplete Low".
The router sends a TCP RST packet and generates this log if you
turn on the firewall TCP reset mechanism (via CI command: "sys
firewall tcprst").
Chapter 20 Logs
281