Push Button Configuration; Wifi Protected Setup (Wps); Figure 64 Wds Link Example - ZyXEL Communications P-660HN User Manual

Chapter 7 Wireless LAN
The following figure illustrates how WDS link works between APs. Notebook computer A is a
wireless client connecting to access point AP 1. AP 1 has no wired Internet connection, but
can establish a WDS link with access point AP 2, which does. When AP 1 has a WDS link
with AP 2, the notebook computer can access the Internet through AP 2.

Figure 64 WDS Link Example

A

7.9.8 WiFi Protected Setup (WPS)

Your ZyXEL Device supports WiFi Protected Setup (WPS), which is an easy way to set up a
secure wireless network. WPS is an industry standard specification, defined by the WiFi
Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device's documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one
device to authenticate the other) in each of the two devices. When WPS is activated on a
device, it has two minutes to find another device that also has WPS activated. Then, the two
devices connect and set up a secure network by themselves.

7.9.8.1 Push Button Configuration

WPS Push Button Configuration (PBC) is initiated by pressing a button on each WPS-enabled
device, and allowing them to connect automatically. You do not need to enter any information.
Not every WPS-enabled device has a physical WPS button. Some may have a WPS PBC
button in their configuration utilities instead of or in addition to the physical button.
Take the following steps to set up WPS using the button.
1 Ensure that the two devices you want to set up are within wireless range of one another.
2 Look for a WPS button on each device. If the device does not have one, log into its
configuration utility and locate the button (see the device's User's Guide for how to do
this - for the ZyXEL Device, see
3 Press the button on one of the devices (it doesn't matter which). For the ZyXEL Device
you must press the WPS button for more than three seconds.
4 Within two minutes, press the button on the other device. The registrar sends the network
name (SSID) and security key through an secure connection to the enrollee.
If you need to make sure that WPS worked, check the list of associated wireless clients in the
AP's configuration utility. If you see the wireless client in the list, WPS was successful.
128
WDS
AP 1
Section 7.5 on page
AP 2
118).
P-660HN-Fx User's Guide