ZyXEL Communications P-660HN User Manual page 78

Chapter 5 WAN Setup
Table 20 Network > WAN > More Connections: Edit (continued)
LABEL
User Name
Password
Service Name
Multiplexing
VPI
VCI
IP Address
Subnet Mask
Gateway IP address
Connection
Nailed-Up Connection
Connect on Demand
Max Idle Timeout
NAT
Back
78
DESCRIPTION
(PPPoA and PPPoE encapsulation only) Enter the user name exactly as
your ISP assigned. If assigned a name in the form user@domain where
domain identifies a service name, then enter both components exactly as
given.
(PPPoA and PPPoE encapsulation only) Enter the password associated
with the user name above.
(PPPoE only) Type the name of your PPPoE service here.
Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC.
By prior agreement, a protocol is assigned a specific virtual circuit, for
example, VC1 will carry IP. If you select VC, specify separate VPI and VCI
numbers for each protocol.
For LLC-based multiplexing or PPP encapsulation, one VC carries multiple
protocols with protocol identifying information being contained in each
packet header. In this case, only one set of VPI and VCI numbers need be
specified for all protocols.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.
This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP
address is not fixed; the ISP assigns you a different one each time you
connect to the Internet.
If you use the encapsulation type except RFC 1483, select Obtain an IP
Address Automatically when you have a dynamic IP address; otherwise
select Static IP Address and type your ISP assigned IP address in the IP
Address field below.
If you use RFC 1483, enter the IP address given by your ISP in the IP
Address field.
This option is available if you select ENET ENCAP in the Encapsulation
field.
Enter a subnet mask in dotted decimal notation.
This option is available if you select ENET ENCAP in the Encapsulation
field.
Specify a gateway IP address (supplied by your ISP).
Select Nailed-Up Connection when you want your connection up all the
time. The ZyXEL Device will try to bring up the connection automatically if it
is disconnected.
Select Connect on Demand when you don't want the connection up all the
time and specify an idle time-out in the Max Idle Timeout field.
Specify an idle time-out in the Max Idle Timeout field when you select
Connect on Demand. The default setting is 0, which means the Internet
session will not timeout.
SUA only is available only when you select Routing in the Mode field.
Select SUA Only if you have one public IP address and want to use NAT.
Click Edit Detail to go to the Port Forwarding screen to edit a server
mapping set.
Otherwise, select None to disable NAT.
Click this to return to the previous screen without saving.
P-660HN-Fx User's Guide