No Security; Basic (Wep Encryption) - ZyXEL Communications VMG1312-B10B Series User Manual

Table 16 Network Setting > Wireless > General (continued)
LABEL
Maximum
Downstream
Bandwidth
BSSID
Security Level
Security Mode
Apply
Cancel

7.2.1 No Security

Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
Note: If you do not enable any wireless security on your Device, your network is
accessible to any wireless networking device that is within range.
Figure 31 Wireless > General: No Security
The following table describes the labels in this screen.
Table 17 Wireless > General: No Security
LABEL
Security Level

7.2.2 Basic (WEP Encryption)

WEP encryption scrambles the data transmitted between the wireless stations and the access points
(AP) to keep network communications private. Both the wireless stations and the access points
must use the same WEP key.
VMG1312-B10B / VMG1312-B30B Series User's Guide
DESCRIPTION
Specify the maximum rate for downstream wireless traffic to this WLAN from the WAN in
kilobits per second (Kbps).
This shows the MAC address of the wireless interface on the Device when wireless LAN is
enabled.
Select Basic (WEP, 802.1X) or More Secure (WPA(2)-PSK, WPA(2)) to add security
on this wireless network. The wireless clients which want to associate to this network must
have same wireless security settings as the Device. When you select to use a security,
additional options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See the following sections for more details about this field.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
DESCRIPTION
Choose No Security to allow all wireless connections without data encryption or
authentication.
Chapter 7 Wireless
105