Table of Contents
Advertisement
Configuration Backup Using GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.
Table 121 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host
Send/Fetch
Local File
Remote File This is the filename on the ZyXEL Device. The filename for the firmware is "ras" and for
Binary
Abort
Refer to
Section 21.1.2 on page 287
over WAN.
21.2 The Firmware Screen
Click Maintenance > Tools to open the Firmware screen. Follow the instructions in this
screen to upload firmware to your ZyXEL Device. The upload process uses HTTP (Hypertext
Transfer Protocol) and may take up to two minutes. After a successful upload, the system will
reboot. See
Section 21.1.4 on page 289
Do NOT turn off the ZyXEL Device while firmware upload is in progress!
Figure 175 Maintenance > Tools > Firmware
P-660HN-Fx User's Guide
Enter the IP address of the ZyXEL Device. 192.168.1.1 is the ZyXEL Device's default IP
address when shipped.
Use "Send" to upload the file to the ZyXEL Device and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
the configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
to read about configurations that disallow TFTP and FTP
for upgrading firmware using FTP/TFTP commands.
Chapter 21 Tools
293
Advertisement
Table of Contents
Troubleshooting
