Table of Contents
Advertisement
Menu Description and Navigation
Menu Tree
INPUT SELECT
Standard Video:
>
Composite
S-Video
Component
High Definition:
Component
RGB
ASPECT RATIO SELECT
INSTALLER ADJUST*
* Menus are only available during "Installer Mode".
(see page 19)
The menu tree above is an overall glance at the menu system in the DLC-2000HD.
The description of the menus and their functions are below.
Main Menu
The main menu includes three main sections:
HD Component, HD RGB),
These menus are described in detail below:
INPUT SELECT is done by highlighting the desired source with the up or down arrows and pressing
ENTER. Sources may also be selected by pressing the left or right arrows on the front panel or
remote, or by one of the direct access buttons on the remote. High Definition or Computer signals are
input to the HDTV port (see page 10).
ASPECT RATIO SELECT is done by highlighting 'Aspect Ratio' on the main menu and pressing
enter. The Aspect Ratio menu will then appear; and either ANAMORPHIC, LETTERBOX or 4:3 may
be selected. Aspect ratios may also be selected by pressing either the up or down arrow buttons, or
by one of the direct access buttons on the remote.
INSTALLER ADJUST is used for adjustments usually made during the initial installation. This
includes Lens Shift, Picture Orientation, Focus, Zoom and Keystone. Also, the age of the lamp in the
Projector (Lamp hours) may be checked in the Installation Menu. See page 19 for details about the
Installation Menu.
Brightness
Contrast
Color Balance*
Anamorphic
Standard 4:3
Letterbox
INPUT SELECT
ASPECT RATIO SELECT
Tint
Color
Brightness
Contrast
Sharpness
Luma Enhance*
Chroma Enhance*
Color Balance*
Lens Focus
Lens Zoom
Lens Shift
Keystone
Picture Orientation
Lamp Hours
(Composite, S-video, Component,
and
INSTALLER ADJUST
15
Red Gain
Green Gain
Blue Gain
Floor
Ceiling
Floor/Rear
001
Ceiling/Rear
.
Advertisement
Table of Contents
