Adjusting Resonance When The Damper Pedal Is Depressed (Sympathetic Resonance); Making The Equalizer Settings (Equalizer); Changing Sound Characteristics (Tone Modify); Restore The Settings To Initial Conditions (Initialize) - Roland RD-700GX Owner's Manual

Adjusting Resonance when the
Damper Pedal is Depressed
(Sympathetic Resonance)
You can adjust this resonance when the damper pedal is
depressed (Sympathetic Resonance).
On an acoustic piano, holding down the damper pedal will
allow the remaining strings to resonate in sympathy with the
sounds that you played from the keyboard, adding a rich
resonance. This feature reproduces that resonance sound.
For details on the parameters you can edit and
their values, refer to "78: SYM.RESONCE
(SYMPATHETIC RESONANCE)" (p. 173).
Making the Equalizer Settings
(EQUALIZER)
This sets the equalization.
For details on the parameters you can edit and
their values, refer to "01: EQUALIZER" (p. 154).
Changing Sound Characteristics
(Tone Modify)
You can make changes in tones by adjusting the settings of the
elements.
Decay Time:
The time it is to take following the attack for the volume to
decrease.
Cutoff:
Adjusts how much the filter is opened.
Release Time:
The time it takes after the key is released for a sound to
become inaudible.
Parameter Value
Decay Time
(Offset)
-64–+63
Cutoff
(Offset)
Release Time
(Offset)
With some Tones, the effect does not work as
NOTE
intended.
Description
The time it takes for the volume
to fall increases as the value is
raised; lowering the value
decreases the decay.
Higher values brighten the
sound; lower values make the
sound seem darker.
Higher values produce longer
decay; set lower values for a
clear-cut sound.
Making Detailed Settings for the ONE TOUCH Tones
Restore the Settings to Initial
Conditions (Initialize)
This restores the One Touch Piano settings to their initial
conditions.
1.
In Step 3 of the Piano Designer settings
instructions (p. 77), select "6. Initialize" and
press the [ENTER] button.
The Initialize Screen appears.
To cancel the Initialize, press the [EXIT/SHIFT] button.
2.
Press the [ENTER] button.
The confirmation message appears.
To cancel the procedure, press the [EXIT/SHIFT] button.
3.
Press the [ENTER] button once again.
The ONE TOUCH [PIANO] button's tones are
initialized.
81