Setting The Transposition For Each Individual Zone (Transpose); Setting The Key Range For Each Zone (Key Range); Changing The Range That Plays In Response To The Velocity (Velocity Range) - Roland RD-700GX Owner's Manual

Setting the Transposition for Each
Individual Zone (Transpose)
You can perform with each zone transposed to a different
pitch.
When multiple zones are set to on, you can create a richer
sound by setting the two Tones to different octaves. Also, if the
Keyboard Mode is set to Split (p. 43) and you are playing a
bass Tone in the lower Part, you can use the Transpose
function to play the bass at a lower pitch.
Parameter
TRA (Transpose)
Setting the Key Range for Each Zone
(Key Range)
Set the keyboard range in which each Zone will sound.
This can be used to make notes in different areas of the
keyboard play different Tones.
Specify the lower limit (LWR) and upper limit (UPR) of the key
range being set.
You can also set this by pressing a specific key and then
pressing the [ENTER] button.
Parameter
LWR (Key Range Lower)
UPR (Key Range Upper)
This is effective only when the [SPLIT] button is on
NOTE
(p. 43) in the key range settings.
"FUL" is displayed when the [SPLIT] button is set to
OFF. In this case, the [SPLIT] button is
automatically switched on when the value is
changed to something other than "FUL" with the
[DEC] [INC] buttons or the VALUE dial.
You cannot set the key range's lower limit higher
than the upper limit, nor can you set the upper limit
NOTE
below the lower limit.
You can use ZONE SWITCH for each individual
zone to select whether or not MIDI Note messages
for that zone are to be transmitted (p. 96).
Value
-48 – 0 –+48
Value
A0–C8
Using the RD-700GX As a Master Keyboard
Changing the Range That Plays in
Response to the Velocity
(Velocity Range)
This specifies the lower limit (LWR) and upper limit (UPR) of the
range in which the tone is played according to how strongly
the keys are played (velocity). Make this setting when you
want the tone to change depending on the key velocity.
Parameter
VRL (Velocity Range Lower)
VRU (Velocity Range Upper)
If you set the minimum velocity to a value above
the upper limit, or set the maximum velocity to a
NOTE
value that is below the lower limit, the setting for
the other limit is changed to the same value.
Value
1–127
101