Roland RD-700GX Owner's Manual page 155

Parameter Value
LPF, BPF, HPF,
Filter Type
NOTCH
Filter Slope -12, -24, -36 dB
Filter Cutoff 0–127
Filter Resonance 0–127
Filter Gain 0– +12 dB
Modulation Sw OFF, ON
TRI, SQR, SIN,
SAW1, SAW2
Modulation
Wave
SAW1
Rate Mode Hz, note
Rate (Hz) 0.05–10.00 Hz
Rate ( ) note (*1)
Depth 0–127
Attack 0–127
Level 0–127
06: STEP FILTER
This is a filter whose cutoff frequency can be modulated in
steps. You can specify the pattern by which the cutoff
frequency will change.
MFX Control Rate, Filter Resonance, Filter Type
Parameter Value
Step 01–16 0–127
Rate Mode Hz, note
Rate (Hz) 0.05–10.00 Hz
Rate ( ) note (*1)
Attack 0–127
LPF, BPF, HPF,
Filter Type
NOTCH
Description
Filter type
Frequency range that will pass
through each filter
LPF: Frequencies below the cutoff
BPF: Frequencies in the region of the
cutoff
HPF: Frequencies above the cutoff
NOTCH: Frequencies other than the
region of the cutoff
Amount of attenuation per octave
-36 dB: Extremely steep
-24 dB: Steep
-12 dB: Gentle
Cutoff frequency of the filter
Increasing this value will raise the
cutoff frequency.
Filter resonance level
Increasing this value will emphasize
the region near the cutoff frequency.
Amount of boost for the filter output
On/off switch for cyclic change
How the cutoff frequency will be
modulated
TRI: Triangle wave
SQR: Square wave
SIN: Sine wave
SAW1: Sawtooth wave (upward)
SAW2: Sawtooth wave (downward)
SAW2
When this is set to "note," the effect is
synchronized with the tempo.
Rate of modulation (Hz)
Rate of modulation (note)
Depth of modulation
Speed at which the cutoff frequency
will change
This is effective if Modulation Wave is
SQR, SAW1, or SAW2.
Output level
Assignable Parameters
Description
Cutoff frequency at each step
When this is set to "note," the effect is
synchronized with the tempo.
Rate of modulation (Hz)
Rate of modulation (note)
Speed at which the cutoff frequency
changes between steps
Filter type
Frequency range that will pass
through each filter
LPF: Frequencies below the cutoff
BPF: Frequencies in the region of the
cutoff
HPF: Frequencies above the cutoff
NOTCH: Frequencies other than the
region of the cutoff
Parameter Value
Filter Slope -12, -24, -36 dB
Filter Resonance 0–127
Filter Gain 0– +12 dB
Level 0–127
07: ENHANCER
Controls the overtone structure of the high frequencies, adding
sparkle and tightness to the sound.
MFX Control Sens, Mix
Parameter Value
Sens 0–127
Mix 0–127
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
08: AUTO WAH
Cyclically controls a filter to create cyclic change in timbre.
MFX Control Manual, Sens, Rate, Depth, Phase
Parameter Value
Filter Type LPF, BPF
Manual 0–127
Peak 0–127
Sens 0–127
Polarity UP, DOWN
Rate Mode Hz, note
Rate (Hz) 0.05–10.00 Hz
Rate ( ) note (*1)
Depth 0–127
Phase 0–180 deg
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
Effect/Parameter List
Description
Amount of attenuation per octave
-12 dB: Gentle
-24 dB: Steep
-36 dB: Extremely steep
Filter resonance level
Increasing this value will emphasize
the region near the cutoff frequency.
Amount of boost for the filter output
Output level
Assignable Parameters
Description
Sensitivity of the enhancer
Level of the overtones generated by
the enhancer
Gain of the low range
Gain of the high range
Output Level
Assignable Parameters
Description
Type of filter
LPF: The wah effect will be applied
over a wide frequency range.
BPF: The wah effect will be applied
over a narrow frequency range.
Adjusts the center frequency at which
the effect is applied.
Adjusts the amount of the wah effect
that will occur in the range of the
center frequency.
Set a higher value for Q to narrow the
range to be affected.
Adjusts the sensitivity with which the
filter is controlled.
Sets the direction in which the
frequency will change when the auto-
wah filter is modulated.
UP: The filter will change toward a
higher frequency.
DOWN: The filter will change toward
a lower frequency.
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of modulation (Hz)
Frequency of modulation (note)
Depth of modulation
Adjusts the degree of phase shift of the
left and right sounds when the wah
effect is applied.
Gain of the low range
Gain of the high range
Output Level
155