Chorus Parameter - Roland RD-700GX Owner's Manual

Effect/Parameter List

Chorus Parameter

The RD-700GX's Chorus effect unit can also be used as a
stereo delay unit.
0: OFF
Neither Chorus or Delay is used.
1: CHORUS
Parameter Value
Filter Type OFF, LPF, HPF
Cutoff Freq 200–8000 Hz
Pre Delay 0.0–100.0 ms
Rate Mode Hz, note
Rate (Hz) 0.05–10.00 Hz
Rate ( ) note (*)
Depth 0–127
Phase 0–180 deg
Feedback 0–127
2: DELAY
Parameter Value
Delay L Mode ms, note
Delay L (ms) 0–1000 ms
Delay L ( ) note (*)
Delay R Mode ms, note
Delay R (ms) 0–1000 ms
Delay R ( ) note (*)
Delay C Mode ms, note
Delay C (ms) 0–1000 ms
Delay C ( ) note (*)
Center Feedbak -98–+98%
200–8000 Hz,
HF Damp
BYPASS
Left Level 0–127
Right Level 0–127
Center Level 0–127
186
Description
Type of filter
OFF: no filter is used
LPF: cuts the frequency range above
the Cutoff Freq
HPF: cuts the frequency range below
the Cutoff Freq
Basic frequency of the filter
Adjusts the delay time from the direct
sound until the chorus sound is heard.
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of modulation (Hz)
Frequency of modulation (note)
Depth of modulation
Spatial spread of the sound
Adjusts the amount of the chorus
sound that is fed back into the effect.
Description
When this is set to "note," the effect is
synchronized with the tempo.
Adjusts the time until the delay sound
is heard. (Hz)
Adjusts the time until the delay sound
is heard. (note)
Settings of the Delay R
The parameters are the same as for
the Delay L.
Settings of the Delay C
The parameters are the same as for
the Delay L.
Adjusts the proportion of the delay
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.
Adjusts the frequency above which
sound fed back to the effect will be
cut. If you do not want to cut the high
frequencies, set this parameter to
BYPASS.
Volume of each delay sound
Volume of each delay sound
Volume of each delay sound
3: GM2 CHORUS
Parameter Value
Pre-LPF 0–7
Level 0–127
Feedback 0–127
Delay 0–127
Rate 0–127
Depth 0–127
Send To Reverb 0–127
note :
(*)
fig.MFX-note2e
(Sixty-fourth-note triplet), (Sixty-fourth note),
(Thirty-second note), (Sixteenth-note triplet),
(Eighth-note triplet),
(Sixteenth note),
(Eighth note), (Quarter-note triplet),
(Quarter note), (Half-note triplet),
(Whole-note triplet), (Dotted half note),
(Double-note triplet), (Dotted whole note),
Description
Cuts the high frequency range of the
sound coming into the chorus.
Higher values will cut more of the high
frequencies.
Volume of the chorus sound
Adjusts the amount of the chorus
sound that is fed back into the effect.
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Frequency of modulation
Depth of modulation
Adjusts the amount of chorus sound
that will be sent to the reverb.
(Thirty-second-note triplet),
(Dotted thirty-second note),
(Dotted sixteenth note),
(Dotted eighth note),
(Dotted quarter note), (Half note),
(Whole note),
(Double note)