Printronix P7010 User Manual page 284

Chapter 7
Diagnosing Problems
Table 15. LCD Message Troubleshooting Table
Can User
Displayed Message
UNKNOWN RBN1 Yes
Install New RBN
UNKNOWN RBN2 Yes
Install New RBN
UP DRV. SHORT* No
WAITING FOR N/A
ETHERNET ADAPTER
1
Before contacting an authorized service representative, power off the printer, wait 15 seconds, then
power it back on and rerun your print job. If the message reappears, press CLEAR. If the fault message still
displays, then contact your authorized service representative.
284
Explanation
Correct?
The sensor detects a bar
code, but the ribbon
model is not permitted on
this printer.
The sensor detects a bar
code, but the region code
does not match the
printer.
Upper Driver Short.
Hammer driver circuits on
the boards shorted to
ground.
Status message: Appears
when the printer is first
powered on if the optional
Network Interface Card is
installed.
Solution
Install a new ribbon.
Install a new ribbon.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
No action is required.
1