Printronix P7010 User Manual page 278

Chapter 7
Diagnosing Problems
Table 15. LCD Message Troubleshooting Table
Can User
Displayed Message
LO DRV. SHORT * No
LOAD PAPER Yes
LOADING PROGRAM No
FROM PORT XX%
LOADING PROGRAM No
INTO FLASH
NEW SPX DETECTED No
PRESS ENTER
NON VOLATILE No
MEMORY FAILED
OLD RIBBON Yes
Install New RBN
ON LINE N/A
ONLINE Yes
28 CU NOT ENAB
ONLINE No
8344 FAILED*
278
Explanation
Correct?
Lower Driver Short.
Circuit(s) on the hammer
bank or in the hammer
bank power cable
shorted to ground.
Printer is out of paper.
Status message: the new
emulation program is
loading into printer RAM.
XX% indicates how much
of the program has
loaded.
The printer has deleted
the previous program
from flash memory and is
loading the new program
into flash memory.
The printer detects an
SPX installed at the
debug port and the SPX
is valid for the printer.
Large emulations reduce
the amount of space
available for saving
configurations, which
means that sometimes
fewer than eight
configurations can be
saved.
The sensor detects a
ribbon that was
previously declared to be
at the end of its service
life.
Printer state message:
printer is online and in
communication with host.
Controller Unit Not
Enabled. Poll
time-out error. The printer
was not polled for one
minute across a coax
interface.
Link-level code test
detects hardware failure.
Solution
Contact your authorized service
1
representative.
Load paper and press CLEAR.
No action is required.
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Install a new ribbon.
No action is required.
Check cable connection and host
system.
Contact your authorized service
1
representative.