Printronix P7010 User Manual page 334

Device ID, 63
Ethernet Address, 64
Form Length, 66, 67
Form Width, 66, 67
Horiz Forms, 67
Host Interface, 63
Margins, 66
Max Line Width, 67
Page Length Rep, 67
PGL SFCC, 65
Power-Up Config, 68
Printer Protocol, 66
P-Series SFCC, 66
Ribbon End Point, 68
Save Config, 68
Select CPI, 66
Select LPI, 66
Vert Forms, 67
WLAN Address, 64
ZTP Data Time, 65
ZTP TearDistance, 65
ZTP Wait Time, 65
R
RBN AT END POINT message, 281
RBN End Action, PRINTER CONTROL, 226
RBN Low Action, PRINTER CONTROL, 226
RBN Low Warn @, PRINTER CONTROL, 226
Ready, Dataproducts Parallel Interface Signals,
235
Receive Data (RD), RS-232, 245
Received CR, ANSI Emulation menu, 173
Received DEL, ANSI Emulation menu, 173
Reload paper, 30
REMOVE USED SPX message, 281
Renew Lifetime, WLAN Kerberos menu, 100
Report Status, Auto Switching submenu, 74
Request to Send
RS-232, 245
Serial submenu, 84
Requirements
power, 19
printer site, 19
334
Reset Cfg Names, 71
Reset Cmd CFG Ld, 143
ANSI Emulation menu, 173
Reset Cmd CFG Ld, PCL-II Emulation, 213
Reset Kerb. Pwd, WLAN Kerberos menu, 100
Reset LEAP Password, WLAN LEAP menu, 101
Reset LEAP User, WLAN LEAP menu, 101
Reset SSID Name, WLAN PARAMS menu, 96
Reset WEP Keys, WLAN PARAMS menu, 98
Reset WPA P-Phs, WLAN PARAMS menu, 99
Resistor configurations, terminating, 241
Resistors
installation, 243
removal, 243
Resistors, terminating
location of, 243
Resp. Polarity
Centronics (Parallel) submenu, 77
Dataproducts, 80
RESTORING BOOT CODE message, 281
RIB INVLD CMD* message, 281
Ribbon Barcode
clean, 45, 251
Ribbon End Point, 68
Ribbon End Point, PRINTER CONTROL, 218
Ribbon Flipping, 13
Ribbon Log, 13
RIBBON STALL message, 281
RIBBON UNDER 2% message, 281
Ribbons, changing, 43
Rot. Char Size, 197
RS-232, 244
Clear to Send (CTS), 245
Data Carrier Detect (DCD), 245
Data Set Ready (DSR), 245
Data Terminal Ready (DTR), 245
Receive Data (RD), 245
Request to Send (RTS), 245
Transmit Data (TD), 245
RS-232 Serial Interfaces, 244
RS-422, 245
RS-422 Serial Interfaces, 244