Full Duplex Mode; Enabling Full Duplex Mode - Nortel 1110 Fundamentals

94 Nortel IP Phone 2002

Full Duplex mode

In the Configuration menu, autonegotiate mode is the default setting for
initial startup. Nortel recommends that autonegotiate mode is used on the
network and the IP Phone. Use Full Duplex mode only when the network
is forced Full Duplex for 100BT Full Duplex mode; otherwise, a duplex
mismatch results. No intervention is required under normal operation.
Changing the speed and changing the duplex mode on the phone changes
both the LAN Ethernet port and PC Ethernet Port interfaces.
Nortel recommends that autonegotiate mode is used on the network and the IP
Phone. Use Full Duplex mode only when the network is forced Full Duplex for
100BT Full Duplex mode; otherwise, a duplex mismatch results.
If the IP Phone connects to a network configured for Full Duplex mode
only, the IP Phone cannot automatically negotiate the proper configuration.
Therefore, in this instance, to allow the IP Phone to work at the optimum
speed and duplex mode, Full Duplex mode must be enabled.
Use
Duplex mode.
Procedure 12

Enabling Full Duplex mode

Step
1
2
3
4
5
6
7
Copyright © 2003–2007, Nortel Networks
.
Procedure 12 "Enabling Full Duplex mode" (page 94)
Action
Reset the phone by disconnecting and reconnecting power.
When the Nortel logo appears in the middle of the display, press
each soft key in sequence. See
Phone 2002" (page
If no other configuration changes are required, press the OK soft key
repeatedly until the Duplex network option appears.
Select 1 to enable Full Duplex mode.
When the Speed option appears, select one of the following:
• 0 for 10 Mb/s
• 1 for 100 Mb/s (default)
Select OK to confirm the change.
Restart the IP Phone. The firmware settings are read and are
applied to UPLINK and the PC Ethernet Port.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
ATTENTION
Procedure 9 "Configuring the IP
75).
—End—
to enable Full