Nortel 1110 Fundamentals page 112

112 Nortel IP Phone 2004
5
6
7
Copyright © 2003–2007, Nortel Networks
.
Figure 9
IP Phone 2004 Ethernet network connections
Connect the AC power adapter (optional). Leave the AC adapter
unplugged from the power outlet, connect the adapter to the AC
adapter jack in the bottom of the phone. Form a small bend in the
cable and then thread the adapter cord through the channels in
the stand.
Secure the IP Phone footstand to the base of the IP Phone. Use
the angle adjustment grip on the top back of the IP Phone to adjust
the position.
Power the IP Phone 2002 using either the Power over Ethernet or an
AC power transformer (local power). If you are using local power,
plug the AC power transformer into the nearest power outlet. Make
sure you use the correct AC power transformer is used. The voltage
rating of the transformer must match the wall outlet voltage. See
Table 12 "IP Phone 2004 component list" (page
The IP Phone 2004 supports both AC power and Power over LAN
options, including IEEE 802.3af Power Classification 2. To use
Power over Ethernet, where power is delivered over the CAT5 cable,
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 01.02 Standard
Release 5.0 20 June 2007
108).