Qosmgr Messages - Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message PORT_SECURITY-6-ADDRESSES_REMOVED: Maximum system secure address count
reached. Some secure addresses configured on port [chars] removed.
Error Message PORT_SECURITY-6-VLAN_REMOVED: VLAN [int] is no longer allowed on port
[chars]. Its port security configuration has been removed.

QOSMGR Messages

This section contains the quality of service (QoS) manager messages. An incorrect QoS setting causes
these messages.
Error Message QOSMGR-3-CANNOT_ERR_DISABLE_DUE_TO_INTERNAL_ERR: Can not put port in
err-disable due to an internal error [chars].
Error Message QOSMGR-3-HW_PROGRAM_PORT_SHAPE_FAIL: Error in programming hardware for
port shape for interface [chars].
OL-9641-04
Explanation Some configured and sticky MAC addresses on the specified port were removed from
the configuration. The number of secure addresses that the system supports was exceeded. This
condition occurs only during hot swapping or port-mode changes (for example, when the port is
converted from a Layer 3 to a Layer 2 port). [chars] is the port.
No action is required.
Recommended Action
A configured VLAN has been excluded either due to a port-mode change or an allowed
Explanation
VLAN list change and is removed from the configuration. [int] is the VLAN ID, and [chars] is the
switch port assigned to the VLAN.
No action is required.
Recommended Action
This message means that an internal software error has occurred. [chars] is the
Explanation
description of the feature that the software cannot find.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the "Error Message Traceback Reports" section on page
This message means that an internal software error has occurred. [chars] is the
Explanation
description of the feature that the software cannot find.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
QOSMGR Messages
1-3.
2-57