Platform_Pm Messages - Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message PLATFORM_PBR-4-CPU_SUPPORTED_ACTION: Set action in sequence [dec] of
route-map [chars] supported by forwarding to CPU.
Error Message PLATFORM_PBR-4-RETRY_INSTALL: Route-map [chars] installed in hardware
upon retry.
Error Message PLATFORM_PBR-4-SDM_MISMATCH: [chars] requires sdm template routing.

PLATFORM_PM Messages

This section contains platform port manager (PM) messages.
Error Message PLATFORM_PM-3-IFCOUNTERROR: Unit number [dec] of interface [chars] is
more than max allowed value of [dec].
OL-9641-04
Explanation This message means that the route-map attached to an interface for policy-based routing
contains an action that is not supported in hardware, so the packets are forwarded to the CPU for
processing. The route-map actions that invoke this forwarding are set interface, set ip default
next-hop, set default interface, or set ip df. [dec] is the action number, and [chars] is the
route-map.
Use the set ip next-hop ip-address route-map configuration command to
Recommended Action
reconfigure the route map action to route the packet to the specified next hop.
This message means that the PBR manager was able to fit the complete configuration
Explanation
into the hardware. One or more route-maps previously failed to load because of lack of resources.
[chars] is the route-map.
No action is required.
Recommended Action
Explanation This message means that the routing template is not enabled. [chars] is the text string
PBR.
Modify the SDM template to enable the routing template. Use the sdm prefer
Recommended Action
routing configuration command, and then reload the switch by using the reload privileged EXEC
command.
This message means that there are too many interfaces configured for the interface type.
Explanation
[dec] is the interface count, [chars] is the interface, and [dec] is the maximum number of interfaces.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
1-3.
PLATFORM_PM Messages
"Error
2-43