Table of Contents
Advertisement
SW_VLAN Messages
Error Message SW_VLAN-4-BAD_STARTUP_VLAN_CONFIG_FILE: Failed to configure VLAN from
startup-config. Fallback to use VLAN configuration file from non-volatile memory.
Explanation
the startup-configuration file. It will use the binary VLAN configuration file in NVRAM memory.
Recommended Action
Error Message SW_VLAN-4-BAD_VLAN_CONFIGURATION_FILE: VLAN configuration file
contained incorrect verification word [hex].
Explanation
not begin with the correct value. The VLAN configuration file is invalid, and it has been rejected.
[hex] is the incorrect verification value.
Recommended Action
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting Cisco, see the
Traceback Reports" section on page
Error Message SW_VLAN-4-BAD_VLAN_CONFIGURATION_FILE_VERSION: VLAN configuration
file contained unknown file version [dec].
Explanation
contained an unrecognized file version number, which might mean an attempt to regress to an older
version of the VLAN manager software. [dec] is the file version number.
Recommended Action
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting Cisco, see the
Traceback Reports" section on page
Error Message SW_VLAN-4-BAD_VLAN_TIMER_ACTIVE_VALUE: Encountered incorrect VLAN
timer active value [chars].
Explanation
active when it should have been inactive or as inactive when it should have been active. [chars] is
the VLAN timer active value.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-82
This message means that the VLAN software did not use the VLAN configuration from
No action is required.
This message means that the VLAN configuration file read by the VLAN manager did
Find out more about the error by using the show tech-support privileged EXEC
1-3.
This message means that the VLAN configuration file read by the VLAN manager
Find out more about the error by using the show tech-support privileged EXEC
1-3.
This message means that, because of a software error, a VLAN timer was detected as
Copy the message exactly as it appears on the console or in the system log.
Chapter 2
Messages and Recovery Procedures
1-3.
"Error Message
"Error Message
"Error
OL-9641-04
Advertisement
Table of Contents
