Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual page 28

DOT1X Messages
Error Message DOT1X-5-ERR_VLAN_RSPAN_CONFIGURED: VLAN [dec] is configured as a
Remote SPAN VLAN, which has Dot1x enabled interface(s) configured. Please disable
Dot1x on all ports in this VLAN or do not enable RSPAN on this VLAN.
Explanation
are configured with 802.1x enabled. [dec] is the VLAN ID.
Recommended Action
on all the ports in this VLAN.
Error Message DOT1X-5-INVALID_INPUT: Dot1x Interface parameter is Invalid on
interface [chars].
Explanation
is the interface.
Recommended Action
parameters.
Error Message DOT1X-5-INVALID_MAC: Invalid MAC address (zero, broadcast or multicast
mac address [chars] is trying to authenticate).
Explanation
multicast MAC address using 802.1x. 802.1x authentication is allowed only for a valid nonzero,
nonbroadcast, or nonmulticast source MAC address.
Recommended Action
Error Message DDOT1X-5-NOT_DOT1X_CAPABLE: Dot1x disabled on interface [chars]
because it is not an Ethernet interface.
Explanation
interfaces. [chars] is the interface.
Recommended Action
Error Message DOT1X-5-SECURITY_VIOLATION: Security violation on the interface
[chars], new MAC address [enet] is seen.
Explanation
host mode that does not support the number of hosts attached to the interface. This is a security
violation, and the port is put in the error-disabled state.
Recommended Action
Enter the shutdown interface configuration command and then the no shutdown interface
configuration command to restart the port.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-16
This message means that remote SPAN should not be enabled on a VLAN in which ports
Either disable the remote SPAN configuration on the VLAN, or disable 802.1x
The IEEE 802.1x interface parameter is out of the specified range or is invalid. [chars]
Refer to the CLI help documentation to determine the valid IEEE 802.1x
This message means that authentication was attempted for a zero, broadcast, or
Connect a 802.1x-supported host to the 802.1x-enabled port.
This message means that you can enable 802.1x authentication only on Ethernet
Enable 802.1x authentication only on Ethernet interfaces.
A host on the specified interface is trying to access the network or to authenticate in a
Ensure that the interface is configured to support the number of attached hosts.
Chapter 2 Messages and Recovery Procedures
OL-9641-04