Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual page 77

Ethernet access switches
Table of Contents

Advertisement

Chapter 2
Messages and Recovery Procedures
Error Message QOSMGR-4-POLICER_POLICY_NOT_SUPPORTED: Number of policers has exceeded
per policy hardware limitation for policymap [chars].
Explanation
the hardware. You configured more policers in a policy map (by using the police or police aggregate
policy-map class configuration command) than supported. [chars] is the policy-map name.
Recommended Action
policers.
Error Message QOSMGR-4-QOSLABEL_EXCEED_MAX: Hardware limitation was reached for
policymaps.
Explanation
the hardware, specifically the number of QoS labels. The QoS label entries needed by this particular
policy map configuration, along with the ones already allocated for any other policy maps attached
to interfaces, cause the total number of required entries to exceed the limit supported by the
hardware for the switch.
Recommended Action
reduce or reconfigure the actions associated with classes to reduce the number of QoS labels.
Error Message QOSMGR-4-QOS_TCAM_RESOURCE_EXCEED_MAX: Exceeded a maximum of QoS TCAM
resources.
Explanation
maximum number of QoS TCAM entries.
Recommended Action
to reduce the number of TCAM entries.
Error Message QOSMGR-4-VLAN_LABEL_EXCEED_MAX: Exceeded a maximum of active vlan
classifications.
Note
Explanation
policies exceeds the maximum number of VLAN classifications that are supported by this hardware.
Recommended Action
of VLANs used for classification.
OL-9641-04
This message means that the policy-map configuration has exceeded the limitation of
Reconfigure the class map or the policy map, and reduce the number of
This message means that the policy map configuration has exceeded the limitations of
Reconfigure the class map, reduce number of classes in the policy map, or
The number of QoS TCAM entries required for all attached QoS policies exceeds the
Reconfigure the class map or reduce the number of classes in the policy map
This message applies only to the Cisco ME 3400E and ME 3400 switches.
The number of VLAN classifications required for all attached per-port, per-VLAN QoS
Reconfigure the attached per-port, per-vlan QoS policies to reduce the number
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
QOSMGR Messages
2-65

Advertisement

Table of Contents
loading

This manual is also suitable for:

Me-2400-24ts-dMe 3400eMe 2400Me 3400 series

Table of Contents