Table of Contents
Advertisement
DOT1X Messages
Error Message DOT1X-5-ERR_PROTO_TUNNELLING: Dot1x can not be enabled on protocol
tunnelling enabled ports.
Explanation
port. Trying to set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a
protocol-tunneling-enabled port, which is not allowed, caused this condition.
Recommended Action
Error Message DOT1X-5-ERR_PVLAN_TRUNK:Dot1x can not be enabled on private VLAN trunk
ports
Explanation
trunking is enabled.
Recommended Action
Error Message DOT1X-5-ERR_RSPAN_VLAN: Dot1x can not be enabled on ports configured
in Remote SPAN vlan.
Explanation
Trying to set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a port that
is in a remote SPAN VLAN, which is not allowed, caused this condition.
Recommended Action
Error Message DOT1X-5-ERR_SPANDST: Dot1x can not be enabled on [chars]. It is
configured as a SPAN Dest port.
Explanation
port because these features are mutually exclusive. [chars] is the port.
Recommended Action
reconfiguring 802.1x on the port.
Error Message DOT1X-5-ERR_TRUNK: Dot1x can not be enabled on Trunk port.
Explanation
802.1x port control to auto or force-unauthorized (force_unauth) mode on a trunk port, which is not
allowed, caused this condition.
Recommended Action
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-14
This message means that 802.1x could not be enabled on the protocol-tunneling-enabled
Change the access VLAN on the interface, and then enable 802.1x.
This message means that 802.1x could not be enabled on private VLAN ports on which
No action is required.
This message means that 802.1x could not be enabled on the remote SPAN VLAN port.
Disable remote SPAN on the VLAN, and then enable 802.1x.
This message means that 802.1x cannot be enabled on a port that is a SPAN destination
Remove the SPAN destination port from the SPAN session before
This message means that 802.1x could not be enabled on the trunk port. Trying to set
Disable trunking on the interface, and then enable 802.1x.
Chapter 2
Messages and Recovery Procedures
OL-9641-04
Advertisement
Table of Contents
