Sw_Vlan Messages - Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual

SW_VLAN Messages

Error Message SW_DAI-6-ACL_PERMIT: [dec] ARPs ([chars]) on [chars], vlan
[dec].([[enet]/[chars]/[enet]/[chars]/[time-of-day]]).
Error Message SW_DAI-6-DHCP_SNOOPING_PERMIT: [dec] ARPs ([chars]) on [chars], vlan
[dec].([[enet]/[chars]/[enet]/[chars]/[time-of-day]]).
SW_VLAN Messages
This section contains the VLAN manager messages. The VLAN manager receives information from the
VTP and enables the proper VLAN membership on all interfaces through the port manager.
Error Message SW_VLAN-3-MALLOC_FAIL: Failed to allocate [dec] bytes
Error Message SW_VLAN-3-VLAN_DAT_CACHE_SEQUENCE: Out of sequence vlan.dat sync
message. Expected: [dec]; received: [dec].
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-80
Explanation This message means that the switch has received ARP packets that are permitted as a
result of an ACL match. The first [dec] is the number of valid ARP packets. The first [chars] is either
Req (request) or Res (response), and the second [chars] is the short name of the ingress interface.
The second [dec] is the ingress VLAN ID. [enet]/[chars]/[enet]/[chars]/[time-of-day] is the MAC
address of the sender, the IP address of the sender, the MAC address of the target, the IP address of
the target, and the time of day.
No action is required.
Recommended Action
This message means that the switch has received ARP packets that have been permitted
Explanation
because the sender's IP and MAC address match the DHCP snooping database for the received
VLAN. The first [dec] is the number of valid ARP packets. The first [chars] is either Req (request)
or Res (response), and the second [chars] is the short name of the ingress interface. The second [dec]
is the ingress VLAN ID. [enet]/[chars]/[enet]/[chars]/[time-of-day] is the MAC address of the
sender, the IP address of the sender, the MAC address of the target, the IP address of the target, and
the time of day.
No action is required.
Recommended Action
Memory allocation failed. [dec] is the number of bytes.
Explanation
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error using the Output Interpreter. Use the Bug Toolkit to look
for similar reported problems. If you still require assistance, open a case with the TA C, or contact
your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Explanation The vlan.dat file is synchronized to the STANDBY through one or more checkpoint
messages from ACTIVE. The sequence number for each set of checkpoint messages starts with 1.
These messages are cached at the STANDBY until the end-of-set indicator is received. The
Chapter 2 Messages and Recovery Procedures
1-3.
"Error
OL-9641-04