Spanning-Tree Pathcost Dynamic; Spanning-Tree Transmit Hold-Count - TRENDnet TL2-G244 User Manual

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots

spanning-tree pathcost dynamic

Command
Default Settings
Command Modes
User Guidelines
Example
Command History

spanning-tree transmit hold-count

Command
Syntax Description
Default Settings
Command Modes
User Guidelines
Example
Command History
28-3
To enable the dynamic pathcost according to the port speed..
spanning-tree pathcost dynamic
no spanning-tree pathcost dynamic
Disable
Global Configuration Mode
1. If the cost has been configured on a CIST or a RSTP interface, then this
command won't take effect on those interfaces.
2. If the cost has been configured on a port of MST instance, then this command
won't take effect on that instance. However, the pathcost of all the other instances
on the same port will still be calculated dynamically.
3. Using no form to disable the dynamic pathcost function.
switch(config)# spanning-tree pathcost dynamic
Version History
1.00.001 This command was introduced
To set a hold counter to limit maximum transmission rate of the Switch.
spanning-tree transmit hold-count <value (1-10)>
no spanning-tree transmit hold-count
Specify the value of hold counter.
value (1-10)
3
Global Configuration Mode
Using no form to reset the hold count to default.
switch(config)# spanning-tree transmit hold-count 10
Version History
1.00.001 This command was introduced