Configuring 100/1000 Mbit/S 9048Gb Ethernet Ports - Avaya Virtual Services Platform 9000 Series Configuration Manual

Variable definitions
Use the data in following table to use the duplex command.
Table 9: Variable definitions
[port {slot/port[-slot/port][,...]}]
<half|full>
Use the data in following table to use the speed command.
Table 10: Variable definitions
[port {slot/port[-slot/port][,...]}]
<10|100>

Configuring 100/1000 Mbit/s 9048GB Ethernet ports

Prerequisites
You must log on to the Interface Configuration mode in ACLI.
Important:
Ensure that all ports that belong to the same MLT or LACP group use the same port
speed.
Configure 100/1000 Mbit/s Ethernet ports so they operate optimally for your network
conditions. These ports use the small form-factor pluggable (SFP) connectors.
Configuration — Ethernet Modules
Variable
Variable
Configuring 100/1000 Mbit/s 9048GB Ethernet ports
Value
Specifies which port to configure the duplex
settings of.
Specifies half-duplex or full-duplex mode for
10/100/1000 Mbit/s ports; 1 and 10 Gbit/s
optical ports must use full-duplex mode.
Value
Specifies the port speed. This option does
not apply to 1 Gigabit or 10 Gigabit Ethernet
modules. Use port {slot/port[-
slot/port][,...]}
ports to the same settings.
The default form of this command is
default speed [port {slot/
port[-slot/port][,...]}]
Specifies the speed of the port in Mbit/s.
to change other
.
June 2011 29