Kodak HR User Manual page 80

Using the Long Roll Accessory
D-16
Loading and Threading Film
IMPORTANT: Careful handling of film is extremely important. Before loading film,
clean the film with Super Film Cleaner or an equivalent cleaner that
has ionized air and particle transfer rollers (PTR).
Use canned air to clean the punch readers before threading film.
Before loading film, make sure you have at least 2 feet (.6 meters)
of leader at each end of the roll.
CAUTION: In the steps below, be sure you determine and use the correct
orientation of the flange. Incorrect setup will result in film tracking
problems and loose takeups.
1. Determine the orientation of the flange for the reel or core you selected for
loading:
• A flange in the upright position is for thin reels
• A flipped flange is for film on cores
• No flanges are needed for thick reels
or
spindle
2. If you are using either thin reels or core only, install the flanges on the spindles
with the appropriate side up.
flange
P192_1549GCA
P192_1549GC
May 2002