2
Connecting and Operating the Scanner
Preparing the Host Computer
May 2002
This chapter gives instructions for:
•
preparing the host computer
•
connecting the HR Film Scanner to the host computer
•
starting up the scanner system
•
preparing to scan an image
•
performing a scan
•
shutting down the scanner
CAUTION: Do not connect power to the scanner.
1. Install the Ultra-Wide SCSI board into the host computer.
IMPORTANT: Check the README file on the CD before you install the
software.
2. Install the SAM software. See Installing the Service and Assembly Module
(SAM) Software on page A-2.
2-1